Update acari_right.overlay

config/boards/shields/acari/acari_right.overlay

@@ -12,7 +12,7 @@
 
 &kscan0 {
     col-gpios
-        = <&xiao_d 4 GPIO_ACTIVE_HIGH>
+        = <&xiao_d 7 GPIO_ACTIVE_HIGH>
         , <&xiao_d 3 GPIO_ACTIVE_HIGH>
         , <&xiao_d 2 GPIO_ACTIVE_HIGH>
         , <&xiao_d 1 GPIO_ACTIVE_HIGH>
@@ -74,8 +74,8 @@
 // But on the corne keyboard, these pins are used for the backlight. So, this
 // example config uses the pins D16 and D10 for clock and data and
 // D9 for the reset circuit.
-#define MOUSE_PS2_PIN_SCL_PRO_MICRO <&xiao_d 10 GPIO_ACTIVE_HIGH>
-#define MOUSE_PS2_PIN_SDA_PRO_MICRO <&xiao_d 9 GPIO_ACTIVE_HIGH>
+#define MOUSE_PS2_PIN_SCL_PRO_MICRO <&xiao_d 5 GPIO_ACTIVE_HIGH>
+#define MOUSE_PS2_PIN_SDA_PRO_MICRO <&xiao_d 4 GPIO_ACTIVE_HIGH>
 
 // Configure the Power-On-Reset pin
 //
@@ -87,7 +87,7 @@
 // trackpoint reset circuit.
 //
 // It's ok to use a low-frequency pin for this.
-#define MOUSE_PS2_PIN_RST_PRO_MICRO <&xiao_d 7 GPIO_ACTIVE_HIGH>
+#define MOUSE_PS2_PIN_RST_PRO_MICRO <&xiao_d 6 GPIO_ACTIVE_HIGH>
 
 
 // Configure SDA pin using the pinctrl notation
@@ -109,7 +109,7 @@
 //
 // We don't define the SCL pin, because UART uses a baud rate instead of
 // a clock pin.
-#define MOUSE_PS2_PIN_SDA_PINCTRL <NRF_PSEL(UART_RX, 1, 14)>
+#define MOUSE_PS2_PIN_SDA_PINCTRL <NRF_PSEL(UART_RX, 0, 4)>
 
 // Configure UART BAUD Rate
 //