The following tests are valid for the following platforms:
- RE-Mote revision A
- RE-Mote revision B
- Firefly
Specific RE-mote revision A examples are available at the rev-a folder.
To flash either hardware platform use the same TARGET=zoul and the following:
- RE-Mote revision A :
BOARD=remote-reva - RE-Mote revision B :
BOARD=remote-revb - Zolertia Firefly :
BOARD=firefly
An example on how to compile is shown next:
make TARGET=zoul BOARD=remote-revb
Or alternatively if you just type make, it will default to use the BOARD=remote-revb.
For backward compatibility with the previous remote target corresponding to the
RE-Mote revision A, using BOARD=remote will default to BOARD=remote-reva.
To upload an example to your Zolertia device, just add the .upload target as:
make TARGET=zoul BOARD=remote-revb zoul-demo.upload
Optionally you can select a specific USB port to flash a given device, in Linux
and assuming there is a device at the /dev/ttyUSB0:
make TARGET=zoul BOARD=remote-revb zoul-demo.upload PORT=/dev/ttyUSB0
If you ommit the PORT argument, the system will flash all Zolertia devices connected over USB.
Just type make login to open a connection to the console via USB.
As above to specify a given port use the PORT=/dev/ttyUSB0 argument.
Alternatively you can save the above PORT, TARGET or BOARD as follows:
export TARGET=zoul BOARD=remote-revb PORT=/dev/ttyUSB0
This will save you to type these when running a command on the terminal
More information about the platforms, guides and specific documentation can be found at Zolertia Wiki