Installation Materials Checklist

These checklists are designed to provide a list of recommended materials and tools needed to install an eMOLT system on a commercial fishing vessel. Not all materials and tools are necessary in all installations because every vessel is different. If you run into a scenario where you need additional tools or materials not covered by this checklist, please let us know so we can make the list more comprehensive

Tools

Reusable, bring these to the boat and bring them home again

• 1/4" Drill Bit (bring several, at least one new)
• 120V AC extension cord reel
• 7/16" wrench x2 or a 7/16" wrench and a 7/16" ratchet/socket (extras are always good)
• Adjustable wrenches (small and medium)
• Bicycle pump
• Charged batteries for any power tools
• Flat head screwdrivers (sizes 1/8 and 3/16)
• Heat gun
• Hex drivers (5 mm and 4.5 mm)
• Lighter
• Mobile phone with hotspot capability or Mobile hotspot
• Multimeter
• Needle nose pliers
• Nut driver (5/16")
• Philips screwdrivers (sizes P0 - P4)
• Pliers
• Power drill (preferably battery powered)
• Pressure chamber (Click here for instruction on how to build one)
• Replacement blades for the utility knife
• Scissors
• Side cutters (large and small)
• Tweezers
• Utility knife
• Wire cutters
• Wire strippers / crimpers

Electronics

• Laptop
• USB WIRED keyboard (NOT wireless)
• USB WIRED mouse (NOT wireless)

Equipment

What you're actually installing

• AC Power Supply with USB-C Cable
• Deckbox
• DC Voltage Converter
• Extra-long (~10') USB-C Cable
• Housing(s)
• Logger(s)

Consumables

Stuff you'll use up eventually. Keep a bunch of this on hand

• Double stick tape
• Velcro strips
• Stainless steel 1.25" self tapping screws
• Zip ties (several sizes, UV resistant)
• Marine heat shrink wrap
• Dielectric grease
• Paper towels
• Electrical tape
• 8x L91 Lithium AA batteries
• Micro fuse (3 Amp, glass)
• Stainless steel fender washers
• Thumb nuts

Spare Parts

For servicing deckboxes and loggers in the field

• 32 GB SSD preinstalled with DDH Software
• 32 GB SD card preinstalled with DDH Software
• SSD to USB adapter
• DC Voltage Converter
• Raspberry Pi 4 Model B
• Juice4Halt board
• USB A to micro b cable (4")
• USB A right angle to micro b right angle (4")
• External Bluetooth USB Cable Assembly (25' - 100')
• External GPS Antenna Assembly
• Replacement legs for deckbox
• Replacement mounting plate for deckbox
• Spare logger