printer-micromake-d1-2016.cfg

# This file contains a configuration for the "Micromake D1" delta
# printer (using the Makeboard 1.3 electronics). To use this config,
# the firmware should be compiled for the AVR atmega2560.

# See the example.cfg file for a description of available parameters.

[stepper_a]
step_pin: ar54
dir_pin: !ar55
enable_pin: !ar38
step_distance: .01
endstop_pin: ^ar2
homing_speed: 100
position_endstop: 319.5
arm_length: 217.0

[stepper_b]
step_pin: ar60
dir_pin: !ar61
enable_pin: !ar56
step_distance: .01
endstop_pin: ^ar15

[stepper_c]
step_pin: ar46
dir_pin: !ar48
enable_pin: !ar62
step_distance: .01
endstop_pin: ^ar19

[extruder]
step_pin: ar26
dir_pin: ar28
enable_pin: !ar24
step_distance: 0.006271
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: ar10
sensor_type: EPCOS 100K B57560G104F
sensor_pin: analog13
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 250
max_extrude_only_distance: 100.0

[fan]
pin: ar9

[mcu]
serial: /dev/ttyACM0
pin_map: arduino

[printer]
kinematics: delta
max_velocity: 300
max_accel: 3000
max_z_velocity: 150
delta_radius: 95

[delta_calibrate]
radius: 80

#[probe]
#pin: ^!ar18

[display]
lcd_type: hd44780
rs_pin: ar16
e_pin: ar17
d4_pin: ar23
d5_pin: ar25
d6_pin: ar27
d7_pin: ar29
encoder_pins: ^ar31, ^ar33
click_pin: ^!ar35
kill_pin: ^!ar41