Positive power lead on keyer/supply broken

[hcarter333]

The lead broke mid QSO attempt. In the end, the leads should be more securely routed under the board.

[hcarter333]

The wire was tinned and then soldered to the top of the board. (The under board connections are a longer term fix, and may not actually do the trick since there will still be strain on the wires. An enclosing box, while clunkier might be the way to go.

[hcarter333]

After #23 the strict power check was performed after the fix. The CAT-5 cable was disconnected, and voltage was measured between terminals 1 and 3 to ensure that it was the correct polarity:

[hcarter333]

Finally, the radio was tested via Utah SDR

1694081218-859917430-8246c943-7e9a-4b73-b6a2-da8dba567807.mp4

Finally putting some numbers to our procedures, the radio was at S7 on the omnidirectional antenna at about 12:32 PM on 12/31/22. (Need better timestamping on twitch stereams.)

SDR for Testing
http://websdr2.sdrutah.org:8902/index1a.html