BMS support for Discover AES batteries

[ironcowboysolar]

Good afternoon. I'm hoping to utilize a few discover AES batteries in parallel with a stack of EG4 Lifepower V2's. I'm under the impression that EG4 uses a Narada BMS. Would it be possible to add support for Discover batteries? I would prefer to have the Discover batteries chained behind the Lynk (the Lynk is a devise that translates the daisy-chained Discover batteries on the "AE Bus" into the selected communication protocol. Then I will have the Lynk (Discover) batteries on CAN address 0 and the EG4 batteries on CAN address 1 both connected to the receive side of the Raspi. The Raspi would ideally utilize can data from both sources and translate it into a single CAN out for my SMA.

I could have both the EG4 and the Discovers communicate on the RS485 inter communication ports and have the Raspi translate them to CAN, but the Discovers don't have a way to designate an address number and i'm not sure how that would work out.

Anyways, I'm interested to hear what you think.

[ai-republic]

Gimme some time on this. Currently very busy and also laying low with a flu