printer-lulzbot-taz6-2017.cfg

# This file contains pin mappings for the Lulzbot TAZ 6 circa 2017. To
# use this config, the firmware should be compiled for the AVR
# atmega2560.

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: PC0
dir_pin: PL1
enable_pin: !PA7
step_distance: .010000
endstop_pin: ^PB6
position_endstop: -20
position_min: -20
position_max: 300
homing_speed: 50

[stepper_y]
step_pin: PC1
dir_pin: !PL0
enable_pin: !PA6
step_distance: .010000
endstop_pin: ^PA1
position_endstop: 306
position_min: -20
position_max: 306
homing_speed: 50

[stepper_z]
step_pin: PC2
dir_pin: PL2
enable_pin: !PA5
step_distance: 0.000625
endstop_pin: ^!PB4
position_endstop: -0.7
position_min: -1.5
position_max: 270
homing_speed: 1

[extruder]
step_pin: PC3
dir_pin: !PL6
enable_pin: !PA4
step_distance: 0.001182
nozzle_diameter: 0.400
filament_diameter: 2.920
heater_pin: PH6
sensor_type: ATC Semitec 104GT-2
sensor_pin: PF0
control: pid
pid_Kp: 28.79
pid_Ki: 1.91
pid_Kd: 108.51
min_temp: 0
max_temp: 300
min_extrude_temp: 140

#[extruder1]
#step_pin: PC4
#dir_pin: PL7
#enable_pin: !PA3
#heater_pin: PH4
#sensor_pin: PF1
#...

[heater_bed]
heater_pin: PE5
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PF2
control: watermark
min_temp: 0
max_temp: 130

[fan]
pin: PH5

[heater_fan nozzle_cooling_fan]
pin: PH3

[mcu]
serial: /dev/ttyACM0

[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 3000
max_z_velocity: 2
max_z_accel: 10

[ad5206 stepper_digipot]
enable_pin: PD7
scale: 2.08
# Channel 1 is E0, 2 is E1, 3 is unused, 4 is Z, 5 is X, 6 is Y
channel_1: 1.34
channel_2: 1.0
channel_4: 1.1
channel_5: 1.1
channel_6: 1.1

# Enable 16 micro-steps on steppers X, Y, Z, E0, E1
[static_digital_output stepper_config]
pins:
    PG1, PG0,
    PK7, PG2,
    PK6, PK5,
    PK3, PK4,
    PK1, PK2

[static_digital_output yellow_led]
pins: !PB7

[display]
lcd_type: st7920
cs_pin: PG4
sclk_pin: PJ2
sid_pin: PG3