printer-creality-ender2-2017.cfg

# This file contains common pin mappings for the 2017 Creality
# Ender 2. To use this config, the firmware should be compiled for the
# AVR atmega1284p.

# Note, a number of Melzi boards are shipped with a bootloader that
# requires the following command to flash the board:
#  avrdude -p atmega1284p -c arduino -b 57600 -P /dev/ttyUSB0 -U out/klipper.elf.hex
# If the above command does not work and "make flash" does not work
# then one may need to flash a bootloader to the board - see the
# Klipper docs/Bootloaders.md file for more information.

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: PD7
dir_pin: !PC5
enable_pin: !PD6
step_distance: .0125
endstop_pin: ^PC2
position_endstop: 0
position_max: 165
homing_speed: 50

[stepper_y]
step_pin: PC6
dir_pin: !PC7
enable_pin: !PD6
step_distance: .0125
endstop_pin: ^PC3
position_endstop: 0
position_max: 165
homing_speed: 50

[stepper_z]
step_pin: PB3
dir_pin: PB2
enable_pin: !PA5
step_distance: .0025
endstop_pin: ^PC4
position_endstop: 0.0
position_max: 205

[extruder]
step_pin: PB1
dir_pin: !PB0
enable_pin: !PD6
step_distance: 0.010753
nozzle_diameter: 0.400
filament_diameter: 1.750
max_extrude_only_distance: 500.0
max_extrude_only_velocity: 200.0
max_extrude_only_accel: 500.0
heater_pin: PD5
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PA7
control: pid
pid_Kp: 21.73
pid_Ki: 1.54
pid_Kd: 76.55
min_temp: 0
max_temp: 250

[heater_bed]
heater_pin: PD4
sensor_type: EPCOS 100K B57560G104F
sensor_pin: PA6
control: pid
# PID Tuned for 60C
pid_Kp: 72.487
pid_Ki: 2.279
pid_Kd: 576.275
min_temp: 0
max_temp: 100

[fan]
pin: PB4

[mcu]
serial: /dev/ttyUSB0

[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 1500
max_z_velocity: 5
max_z_accel: 100

[display]
lcd_type: uc1701
cs_pin: PA3
a0_pin: PA1
encoder_pins: ^PD2, ^PD3
click_pin: ^!PC0