generic-radds.cfg

# This file contains common pin mappings for RADDS (v1.5) boards.  To
# use this config, the firmware should be compiled for the Arduino
# Due.

# See the example.cfg file for a description of available parameters.

# Temp sensor pins: analog0..analog4
# Mosfet Pins: ar7 (Heatbed), ar8, ar9, ar11, ar12, ar13

[stepper_x]
step_pin: ar24
dir_pin: ar23
enable_pin: ar26
step_distance: .0125
endstop_pin: ^ar28
#endstop_pin: ^ar34
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_y]
step_pin: ar17
dir_pin: !ar16
enable_pin: ar22
step_distance: .0125
endstop_pin: ^ar30
#endstop_pin: ^ar36
position_endstop: 0
position_max: 200
homing_speed: 50

[stepper_z]
step_pin: ar2
dir_pin: ar3
enable_pin: ar15
step_distance: .0025
endstop_pin: ^ar32
#endstop_pin: ^ar38
position_endstop: 0.5
position_max: 200

[extruder]
step_pin: analog7
dir_pin: analog6
enable_pin: analog8
step_distance: .002
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: ar13
sensor_type: EPCOS 100K B57560G104F
sensor_pin: analog0
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_temp: 0
max_temp: 250

#[extruder1]
#step_pin:           analog10
#dir_pin:            analog9
#enable_pin:         analog11

#[extruder2]
#step_pin:           ar51
#dir_pin:            ar53
#enable_pin:         ar49

[heater_bed]
heater_pin: ar7
sensor_type: EPCOS 100K B57560G104F
sensor_pin: analog1
control: watermark
min_temp: 0
max_temp: 130

[fan]
pin: ar9

#[heater_fan nozzle_cooling_fan]
#pin: ar8

[mcu]
serial: /dev/ttyACM0
pin_map: arduino

[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 3000
max_z_velocity: 5
max_z_accel: 100

# "RepRapDiscount 2004 Smart Controller" type displays
#[display]
#lcd_type: hd44780
#rs_pin: ar42
#e_pin: ar43
#d4_pin: ar44
#d5_pin: ar45
#d6_pin: ar46
#d7_pin: ar47

# "RepRapDiscount 128x64 Full Graphic Smart Controller" type displays
#[display]
#lcd_type: st7920
#cs_pin: ar42
#sclk_pin: ar44
#sid_pin: ar43